The TMCM-6110 coolStep™ is a 6-axis stepper controller/driver 1.1A/24V

The TMCM-6110 is an intelligent, compact and ‘ready to use’ 6 axis motion control solution at low cost for up to six bipolar 2-phase stepper motors. It fully supports the common and easy to use programming language TMCL™, where predefined high level motion control commands such as ‘Move to Position’ or ‘Constant Rotation’ guarantee convenient and rapid development.

Features

  • Up to 256 times microstep
  • StallGuard2™ for sensorless load detection
  • CoolStep™ for load dependent current control
  • SpreadCycle™ chopper for smooth current wave form
  • Ready for dcStep™ feature: auto-ramping and load depending speed adjustment
  • Memory for 2048 TMCL™ commands
  • Automatic ramp generation in hardware
  • ‘On the fly’ alteration of motion parameters (e.g. position, velocity, acceleration)
  • Integrated protection: over-temperature/under-voltage
  • Full step frequencies up to 20kHz
  • TRINAMIC driver technology therefore no heatsink required
  • 8x DIP switch for addressing or general purpose

Besides the user programmable I/O controlled stand alone operation (onboard memory), a variety of high level interfaces allow remote controlled operation. Since all time critical operations, for example ramp calculation, are performed onboard, the communication traffic is kept very low. Inimitable smooth, precise and fast movements are given by a resolution of up to 256 electrically equi-distant microsteps and by the ultimate spreadCycle™ chopper scheme for optimal motor currents.

In addition the TMCM-6110 features the following revolutionising technologies: stallGuard2™ can detect and monitor dynamic load changes in high resolution without the need of an encoder, it builds the basis for the automated load dependent current control coolStep™ for energy/ heat efficient motor control, as well as giving unlimited motor performance.

Electrical Data

  • Up to 1.1A coil current RMS (1.5A peak)
  • 9V to 28V supply voltage

Supported Motors

  • Two-phase bipolar motors with up to 1.1A coil current

Interface

  • RS485 (9pin D-SUB connector)
  • CAN (9pin D-SUB connector)
  • USB 2.0 full speed (mini USB connector)
  • 2 reference / limit switch input per axis
  • 6 general purpose digital inputs (24V compatible)
  • 2 general purpose analogue input (0-10V, 12-bit)
  • 6 general purpose digital outputs (open drain, 100mA)
  • 2 general purpose digital outputs (open drain, 1A)

Software

  • stand-alone or remote controlled operation using TMCL™ (Trinamic Motion Control Language)
  • PC-based application development soft-ware TMCL-IDE is included

Saving the best until last, the price, 100 pieces are just £120.00 each (that’s £20 per axis) and for a 1000 pieces they are only £100 each, an incredible £16.60 per axis *

Micromech is the UK and Eire distributor for these amazing products and if you would like a quote or to find out more contact Stirling Morley on 01376 333333 or email stirling@micromech.co.uk

‘Affordable Automation’

* best prices, one shipment

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

%d bloggers like this: